RENT Pacific Power Source 320AMX AC Power Source (Call for availability)
The Pacific Power 320AMX AC power source enables a variety of power conditions and transients to be applied to the device under test while metering and analyzing all output performance parameters. the 320AMX offers low output voltage noise and distortion, ease of installation, and high AC waveform fidelity. Three controller models are available in both manual and programmable control version. All controllers provide manual operation from the front panel. Programmable Controllers may be operated from the front panel or from a remote interface via RS 232 or GPIB.
With the ability to provide either single or two phase output, the 320AMX AC power source is a good choice to convert three-phase line voltage into precisely controlled split (two-phase) or singlephase output power. All Pacific Power 320AMX sources are equipped with a powerful micro-controller with the ability to operate as a fully integrated test system. The output frequency is quartz-crystal stabilized. Output voltages up to 270VL-L in split phase mode and 234VL-L in three phase mode are available on the 320AMX. The exceptionally broad bandwidth (50 kHz small signal), combined with low output impedance and high crest factor ratings give the 320AMX AC power source the ability to produce high quality, low distortion output power into the most dynamic loads.
Specifications of the Pacific Power Source 320AMX AC Power Source includes:
AC Power | 2000VA |
Voltage Low/High | 0-135V/0-270V |
Frequency | 20-5000Hz |
Output Current Low/High | 18A/6A |
Unit Height | 5U (8.75 in) |
See Datasheet for Full Specifications
Testimonials |
Axiom Test has an excellent range of test equipment and is always super responsive to short notice requests. They are an extension of our quality and engineering team with the support they provide us. Thanks! -- Eric G. Phoenix, AZ |